When you need to position your Aimpoint further forward, this is your QD mount.
The LT129 Cantilever QD CompM2 mount pushes your Aimpoint out over the D-ring...leaving more room behind to mount your NV stuff or even an Aimpoint 3X Magnifier. The base has a built-in watertight storage compartment for an extra battery...comes in handy

The LT129 positions the centerline of the optic 1.7" above the top of the rail.

Like all LaRue mounts, it is precision-machined out of bar-stock aluminum and matt black anodized to provide a durable non-reflective surface finish. The locking LaRue Speed Lever provides outstanding return to zero; the optic can be removed, and replaced, without loss of zero. Guaranteed.

Comes complete with QD adjustment wrench, spare ring screw, vial of blue Locktite and Instructions.

Available with LaRue QD Speed Levers or VFZ mounts (see pull-down to the right)

About VFZ Mounts:
VFZ is a new theory in the concept of clamping accessories to MIL-STD-1913 rails. Instead of using a horizontal cross-bolt, the VFZ uses a vertical bolt that draws up a clamping foot against the lower angle of the rail, seating the mount similarly to a fully-closed LaRue lever.

Once installed on the firearm, index marks allow the user to remove the mount, then reattach to the same tension, providing unprecedented return to zero for a non-QD-levered mount. The unique vertical alignment of the clamp allows components that are structurally stronger than traditional cross-bolt designs.